Photos
You take a photo with the camera straight from the app or pick one from the phone's gallery. We explain how an item photo differs from a measurement photo, where to find them later and what happens to them after upload.
Why take photos
A dimension tells you how big the window should be. A photo tells you what is around it — and that usually decides whether the installation goes smoothly.
An old sill to be chiselled out, a radiator under the window, an uneven reveal, a pipe running through the opening, a facade that must not be damaged. None of these fits in a dimension field, and each can extend the installation by half a day.
The second use is a dispute after the fact. A photo taken before installation settles whether the scratch on the sill was already there.
Two places where photos live
- Item photo
- Assigned to a specific window or door. You take it in field mode, at the “Photo” step of that item's wizard.
- Measurement photos
- Assigned to the whole visit, not to a single item — a view of the room, the facade, access, the unloading spot. You add them on the measurement record, which holds any number of them.
Viewing and deleting
On the measurement record, photos are shown as thumbnails. Clicking one opens a full-screen view, the arrows take you to the next one, and the bottom shows which photo it is out of how many — for example “3 / 7”.
Each thumbnail has a delete button. Deletion is immediate and there is no bin, so make sure the photo really is unnecessary.
What happens after upload
Rotation based on the camera data matters more than it sounds: without it, every other photo from a phone would appear sideways on the printout.
Photos on the measurement document
The measurement protocol template can contain a photo gallery in one of three layouts: single large, two columns or thumbnails in four columns. You choose it like any other block — see Document template editor.
Photos and no signal
Photos do not wait in a queue the way dimensions do. The file would not fit in the browser's storage, so uploading requires a connection — without one the app says so plainly instead of pretending the photo has been saved.
In practice: in the basement you record the dimensions, and you add the photos once you are back in range or back at the office, by opening the measurement again. This is described in Automatic synchronisation.
